Mains harmonic comb and power-line noise
- Channels
- every 50 Hz
- Modes
- Broadband noise
- Allocation
- Reserved
- Region
- Worldwide
- Service
- Unintentional radiation from power distribution
- Importance
- ●●●○○
The harmonic tail of the power grid: a comb of tones every 50 or 60 Hz that dominates the audio-frequency and VLF noise floor near any built-up area.
Non-linear loads - rectifiers, LED drivers, variable-speed motor controllers, arc furnaces - inject harmonic currents back into the grid, and every conductor then acts as an antenna. Odd harmonics (3rd, 5th, 7th) dominate in a balanced three-phase system; triplen harmonics accumulate in the neutral. Above the audio range this merges into broadband 'power line noise' from arcing hardware, cracked insulators and loose ground straps, which is the number one man-made interference source right through LF, MF and HF. On an SDR it sounds like a harsh 100 Hz or 120 Hz buzz that gets worse in dry weather and often peaks on one phase. Utilities hunt it with directional VHF sniffers. For an ELF/VLF listener the practical answer is battery power, a rural site, and a 50/60 Hz comb notch in software.
Inside this band
Nearby
- 1–3 HzGeomagnetic micropulsations / DC field variations (Pc1-Pc5, Pi)
- 6–60 HzSchumann resonance harmonic series (modes 1-8)
- 7–8 HzSchumann resonance fundamental (7.83 Hz)
- 0.2–5 kHzChorus, hiss and other magnetospheric emissions
- 0.3–30 kHzSferics (lightning atmospherics)
- 1–10 kHzWhistlers
- 1–100 kHzClaimed seismo-electromagnetic earthquake precursors (VLF/ULF)