Qi inductive wireless charging (87-205 kHz)
- Modes
- Inductive, ASK/FSK in-band signalling
- Allocation
- Unlicensed
- Region
- Worldwide
- Service
- Consumer inductive wireless power transfer
- Licence
- Device authorisation
- Power
- 5-15 W (Baseline/Extended Power Profile)
Phone and earbud charging pads operate at 87-205 kHz - directly on top of the longwave broadcast band, and a growing LF interference problem.
The Wireless Power Consortium's Qi standard runs its power transfer at 110-205 kHz for the Baseline Power Profile and down to 87 kHz for the Extended Power Profile, with the receiver signalling back to the transmitter by modulating its load. Because the coils are tightly coupled and shielded, the intended radiation is small, but harmonics and switching transients are not, and a Qi pad sitting on a desk will comprehensively wipe out longwave and even mediumwave reception on any portable radio nearby - the fundamental sits squarely inside the 148.5-283.5 kHz European broadcast band. This has been documented repeatedly by broadcasters and regulators, and is one of many reasons LF reception in a modern home is far harder than it was 30 years ago. Related: Qi2 adds magnetic alignment but keeps the same frequency range, and higher-power appliance and EV standards sit lower, at 79-90 kHz.
Inside this band
Part of
Nearby
- 10–200 kHzInductive loop vehicle detectors (traffic signals)
- 10.2–13.6 kHzOMEGA global radionavigation system (historical)
- 70–129 kHzDecca Navigator System (70-129 kHz) - closed 2000
- 79–90 kHzWireless power transfer for electric vehicles (SAE J2954, 79-90 kHz)
- 190–535 kHzNon-directional beacons (NDB) - aviation and marine
- 0.19–1.75 MHzAircraft ADF / radio compass receiver coverage (190-1750 kHz)
- 283.5–325 kHzMarine DGPS radiobeacons (Region 1: 283.5-315 kHz; Regions 2/3: 285-325 kHz)
- 0.3–3 MHzMF band (300 kHz - 3 MHz) overview