Cat's Whisker
Industrial Allocation

Inductive loop vehicle detectors (traffic signals)

10–200 kHz
190 kHz wide · Low frequency
Modes
Oscillator
Allocation
Unlicensed
Region
Worldwide
Service
Vehicle presence detection
Licence
Device authorisation
Confidence
Medium

The wire loops cut into road surfaces at traffic lights oscillate at tens of kilohertz and shift frequency when a car sits on them.

A saw-cut loop of a few turns of wire in the road forms the inductor of an oscillator running typically between 10 and 200 kHz (commonly 20-80 kHz). A vehicle's steel body acts as a shorted turn, lowering the loop inductance and raising the frequency by a fraction of a percent; the detector card watches for that step and calls the signal phase. Adjacent loops are deliberately run at different frequencies to avoid crosstalk, and multiplexed detectors scan several loops in turn, producing a characteristic hopping pattern. They are near-field devices, so radiation is small, but a VLF receiver carried past a signalised intersection will hear them clearly, and motorcyclists' complaints about loops failing to detect them come from exactly this physics - too little conductive area to shift the inductance enough.

Inside this band

Part of

Nearby

Sources