Metal detectors and inductive sensing (VLF/LF)
- Modes
- Continuous wave, Pulse induction
- Allocation
- Unlicensed
- Region
- Worldwide
- Service
- Electromagnetic induction sensing
- Licence
- Device authorisation
- Confidence
- Medium
Hobby and security metal detectors transmit a few kHz to ~100 kHz continuously, and pulse-induction machines radiate broadband impulses.
A very-low-frequency metal detector runs a transmit coil at typically 3-30 kHz (lower for deep-seeking gold machines, higher for small-target sensitivity) and measures the phase and amplitude of the field induced in a nearby receive coil; a conductive target shifts both, and the phase shift is what lets a detector discriminate iron from silver. Pulse-induction machines instead fire a strong current pulse into the coil and measure the decay of eddy currents after switch-off, which works better in mineralised ground and salt water but radiates broadband impulses. Walk-through security archways are similar devices at higher power. All of these are near-field devices governed by field-strength limits, but a detector operating close to a VLF receiver is deafening, and two detectorists working within about 10 m of each other on the same frequency will interfere - which is why machines often offer a small frequency shift setting.
Inside this band
- 3–30 kHzVLF band (3-30 kHz) overview
- 8.3 kHzNatural radio / 'dreamers band' sub-9 kHz experimental
- 9 kHz9 kHz - the historic bottom edge of the ITU Radio Regulations
- 10.2–13.6 kHzOMEGA global radionavigation system (historical)
- 58 kHzAcousto-magnetic electronic article surveillance (58 kHz)
- 79–90 kHzWireless power transfer for electric vehicles (SAE J2954, 79-90 kHz)
- 100 kHzLORAN-C / Chayka hyperbolic radionavigation (100 kHz)
- 100 kHzeLoran (enhanced Loran) - GPS backup revival
Part of
Nearby
- 0.2–5 kHzChorus, hiss and other magnetospheric emissions
- 0.3–3 kHzThrough-the-earth (TTE) mine communications, ULF/VLF band
- 0.3–30 kHzSferics (lightning atmospherics)
- 1–10 kHzWhistlers
- 10–200 kHzInductive loop vehicle detectors (traffic signals)
- 0.01–3 MHzElectric fence energisers (impulse QRM)
- 0.02–3 MHzSolar radio bursts (type II and type III, kilometric and hectometric)
- 30–300 kHzLF band (30-300 kHz) overview